Categories

Email us

Best sellers

  • Bend support pipes fi 20-22
    Underfloor Heating Pipe 16mm...

    16mm pipe bending supports for underfloor heating pipe

    £0.80 tax excl.
  • Actuators for UFH
    LK Actuators

    Actuator for use with LK underfloor heating manifold.  Note: for...

    £16.00 tax excl.
  • M10 Backplate (Stainless Steel)
    M10 Backplate

    M10 Backplate suitable for 10mm threaded steel rod

    £0.50 tax excl.
All best sellers

Retrofit Underfloor Heating using LK Minishunt M60n I Ideal for areas up to 60m2

Thermostat controlled shunt unit for use when smaller underfloor heating systems are to be connected to an existing heating system. The shunt unit is to be used in systems with the main pump in the primary circuit. Its capacity can be set at a flat rate of heating requirements of 50 W/m² to max 60 m² of floor heating area. The capacity is dependent on the primary temperature, pressure, floor heating installing system, etc. Then Shunt unit can be connected to series or parallel radiator systems. Assembly can be made in right or left operation.

Complete premanufactured shunt unit includes;
• Circulation pump Wilo Yonos Para RSB 15/6-RKA, with automatic speed control, 1 phase 230 V AC, 50 Hz, max 45 W, 0,44 A 
• Thermostat with room temp. sensor length 2 m 
• Connectors for primary pipe connection 2 pcs CU15 
• Temperature limiter of feed temperature 
• VF valve 
• Fill and drain valve and air bleed valve with the hose nipple 
• Bracket

LK Minishunt M60n is a shunt group intended for use when smaller underfloor heating areas are to be connected to an existing heating system. LK Minishunt M60n adapts the heating system temperature to the lower temperature necessary for the underfloor heating system. Its capacity can normally be set at a heating need of 50 W/ m² to a maximum 60 m² underfloor heating area. Capacity is however dependent on primary temperature, pressure, laying method etc.

• For underfloor heating areas up to 60 m2.

• Compact design.

• Energy efficient circulation pump.

• Thermostat-controlled maximum limit of supply temperature.

• Switchable between single or twin pipe systems.

• VF valve.

• Easy filling & air bleeding.

• Expandable to 2, 3 or 4 underfloor heating circuits.

Supplied with product

• Circulation pump Wilo Yonos Para RSB 15/6- RKA, with automatic speed control.

• Thermostat with capillary tube sensor, length 2 m.

• Thermometer to place in one of the shunt group's thermometer pockets.

• Hose 0.5 m for air bleeding.

• Primary connector ¾" EuroCone and 2 connectors for CU15.

• Bracket.

Comments

Leave your comment