Categories

Email us

Best sellers

  • Actuators for UFH
    LK Actuators

    Actuator for use with LK underfloor heating manifold.  Note: for...

    £16.00
  • M10 Backplate (Stainless Steel)
    M10 Backplate

    M10 Backplate suitable for 10mm threaded steel rod

    £0.50
  • 50mm Hand Push Staples (200 pieces)
    Underfloor Heating Fixings

    50mm Tacker Staples (250 pieces) Underfloor Heating Staples to fix 16mm...

    £6.01
All best sellers

LK Slotted Board EPS 16 I Retrofit Underfloor Heating System

LK Slotted Board EPS 16 I Retrofit Underfloor Heating System

LK Slotted Board EPS 16 I Retrofit Underfloor Heating System

EPS16 Slotted Board 1200mm x 600mm x 16mm

LK Slotted Board EPS 16 is the solution for anyone who is renovating a room with restricted height. The insulated, pre-grooved panel is only 16 mm thick and is installed over existing solid floors. 

Call us now 0141 404 6204 or email us shop@renewableproductswarehouse.com

Online only

£18.99

Add to cart

Add to my wishlist

By buying this product you can collect up to 1 loyalty point. Your cart will total 1 point that can be converted into a voucher of £0.20.

Customers who bought this product also bought:

2 other products in the same category:

More info

LK Heating Board made of EPS (polystyrene) 16 mm thick with a full cover aluminium heat distribution sheet. The board has 4 pcs slots centred at 150 mm for LK Floor Heating Pipe Ø 12 mm. 

The heating pipe loops are simply pushed into the panel grooves, which is entirely covered by a bonded aluminium plate; heat from the pipes is spread evenly across the entire floor surface, with little downward heat loss.

Load bearing flooring is then installed directly on top of the panel. If, for example, you decide to lay tiles over the floor heating installation, the total installation height is only 26 mm.

  • Ideal for renovation
  • Cuts downward heat loss
  • Suitable under all types of final flooring
  • Low installation height: from 25 mm

Compression strength short time load (ISO 844) 400 kPa. 
Long lasting compression strength: 140 kPa (2% compr. in 50 years). 
Thermal conductivity 0,034 W/m ºC.

Material consumption:

  • Approx. 1,5 pcs/m² excl. turning zone surface

Download

Accessories